M12 Drill/Driver Friction Fit Holder
Last updated
Was this helpful?
Last updated
Was this helpful?
A parametric design intended to keep the non-Fuel drill/driver combo held in place during travel in an RV. It should be a one-handed remove and work under-desk or on wall.
The Fusion 360 file was built with a single :innerDia which is the inner diameter of the main cylindrical shape. The rest of the design should generate from there for most reasonable and possibly unreasonable values of innerDia.
The following are parameters used for the tools I own:
2462-20 Driver - 55mm
Printed nicely with PETG - tight friction fit
2407-20 Drill - 60mm
Printing
